SCHEDULE II


See Rule 3(2) .- A. The test and inspection certificates to be obtained from the Inspecting Authority in respect of cylinders manufactured in accordance with the approved design and specification or Code shall include the following particulars, namely:--



1. Place and date of inspection.



2. Gas cylinders for ..........................................



3. Manufactured by ..........................................



4. Location at ..........................................



5. Manufactured for ..........................................



6. Location for ..........................................



7. Quantity ..........................................



8. Serial Nos. from...to ..........................................inclusive.



9. Specification to which the cylinders ae manufactured.



10. Size......mm. Outside diameter mm ..........................................long.



11. Minimum wall thickness ..........................................



12. Neck end threading as per ..........................................specification.



13. Process of manufacture (whether spun type, or billet pierced or welded).



14. Method of heat treatment.



15. Design working pressure in Kg/cm2 at 150 C or 650C as the case may be.



16. Hydrostatic test/hydrostatic stretch test pressure in KG/CM2.



17. Record of Hydrostatic test/Hydrostatic stretch test with date of test, in respect of each cylinder.



18. Pneumatic test pressure in Kg/cm2.



19. Result of pneumatic test.



20. Tare weight and water capacity of each cylinder.



21. Record of chemical analysis and physical properties of the steel used in the manufacture of cylinders.



22. Manufacturer's identification marks.



23. Inspector's mark.



24. Markings stamped on the shoulder of the cylinders.



25. Dated signature with stamp of the inspecting authority.



B. The test and inspection certificates to be obtained from the Inspecting Authority in respect of valves manufactured in accordance with the approved design and specification or Code shall include the following particulars, namely:-



1. Manufactured by-



2. Location at-



3. Manufactured for-



4. Location at-



5. Quantity-



6. Specification-



7. Results of inspection-



(a) Valve inlet connection.



(b) Valve outlet connection.



(c) Valve outlet number.



(d) Hydraulic Pressure Test.



(e) Pneumatic Proof Test.



(f) Tensile strength.



(g) Elongation per cent.



(h) Impact strength.



(i) Quantity offered for inspection.



(j) Quantity pases.



(k) Quantity rejected and reasons for rejection.



8. Dated signature with stamp of the inspecting authority.



#LawyerServices #Section #Act #Law #Statute #IndianLaw #Kanoon